最新免费av在线观看,亚洲综合一区成人在线,中文字幕精品无码一区二区三区,中文人妻av高清一区二区,中文字幕乱偷无码av先锋

LPC47M172_07 Datasheet

  • LPC47M172_07

  • SMSC Corporation [Advanced I/O Controller with Motherboard ...

  • 1113.49KB

  • SMSC   SMSC

掃碼查看芯片數據手冊

上傳產品規格書

PDF預覽

Advanced I/O Controller with Motherboard GLUE Logic
Datasheet
7.4.8
EPP Data Port 3
ADDRESS OFFSET = 07H
The EPP Data Port 3 is located at an offset of 鈥?7H鈥?from the base address. Refer to EPP DATA PORT 0
for a description of operation. This register is only available in EPP mode.
7.5
EPP 1.9 Operation
When the EPP mode is selected in the configuration register, the standard and bi-directional modes are
also available. If no EPP Read, Write or Address cycle is currently executing, then the PDx bus is in the
standard or bi-directional mode, and all output signals (STROBE, AUTOFD, INIT) are as set by the SPP
Control Port and direction is controlled by PCD of the Control port.
In EPP mode, the system timing is closely coupled to the EPP timing. For this reason, a watchdog timer is
required to prevent system lockup. The timer indicates if more than 10usec have elapsed from the start of
the EPP cycle to nWAIT being deasserted (after command). If a time-out occurs, the current EPP cycle is
aborted and the time-out condition is indicated in Status bit 0.
During an EPP cycle, if STROBE is active, it overrides the EPP write signal forcing the PDx bus to always
be in a write mode and the nWRITE signal to always be asserted.
7.5.1
Software Constraints
Before an EPP cycle is executed, the software must ensure that the control register bit PCD is a logic 鈥?鈥?/div>
(i.e., a 04H or 05H should be written to the Control port). If the user leaves PCD as a logic 鈥?鈥? and
attempts to perform an EPP write, the chip is unable to perform the write (because PCD is a logic 鈥?鈥? and
will appear to perform an EPP read on the parallel bus, no error is indicated.
7.6
EPP 1.9 Write
The timing for a write operation (address or data) is shown in timing diagram EPP Write Data or Address
cycle. The chip inserts wait states into the LPC I/O write cycle until it has been determined that the write
cycle can complete. The write cycle can complete under the following circumstances:
1.
2.
If the EPP bus is not ready (nWAIT is active low) when nDATASTB or nADDRSTB goes active then
the write can complete when nWAIT goes inactive high.
If the EPP bus is ready (nWAIT is inactive high) then the chip must wait for it to go active low before
changing the state of nDATASTB, nWRITE or nADDRSTB. The write can complete once nWAIT is
determined inactive.
Write Sequence of Operation
1.
2.
3.
4.
5.
The host initiates an I/O write cycle to the selected EPP register.
If WAIT is not asserted, the chip must wait until WAIT is asserted.
The chip places address or data on PData bus, clears PDIR, and asserts nWRITE.
Chip asserts nDATASTB or nADDRSTRB indicating that PData bus contains valid information, and the
WRITE signal is valid.
Peripheral deasserts nWAIT, indicating that any setup requirements have been satisfied and the chip
may begin the termination phase of the cycle.
The chip deasserts nDATASTB or nADDRSTRB, this marks the beginning of the termination phase.
If it has not already done so, the peripheral should latch the information byte now.
Page 94
SMSC LPC47M172
6. a)
SMSC/Non-SMSC Register Sets (Rev.
01-11-07)
DATASHEET

LPC47M172_07 PDF文件相關型號

LPC47M172-NW

LPC47M172_07相關型號PDF文件下載

  • 型號
    版本
    描述
    廠商
    下載
  • 英文版
    100 PIN ENHANCED SUPER I/O CONTROLLER WITH LPC INTERFACE
    SMSC
  • 英文版
    100 PIN ENHANCED SUPER I/O CONTROLLER WITH LPC INTERF...
    SMSC [SMSC...
  • 英文版
    128 Pin Enhanced Super I/O with LPC Interface for Consumer A...
    SMSC
  • 英文版
    128 Pin Enhanced Super I/O with LPC Interface for Con...
    SMSC [SMSC...
  • 英文版
    100 Pin Enhanced Super I/O for LPC Bus with SMBus Controller...
    SMSC
  • 英文版
    100 Pin Enhanced Super I/O for LPC Bus with SMBus Con...
    SMSC [SMSC...
  • 英文版
    Microcontroller
    ETC
  • 英文版
    SMSC Corporation [100 Pin Enhanced Super I/O Controller wit...
    SMSC
  • 英文版
    ENHANCED SUPER I/O CONTROLLER WITH LPC INTERFACE
    SMSC
  • 英文版
    ENHANCED SUPER I/O CONTROLLER WITH LPC INTERFACE
    SMSC [SMSC...
  • 英文版
    LPC47M13x_SMSC Corporation.pdf
    SMSC Corporatio...
  • 英文版
    128 PIN ENGANCED SUPER I/O CONTROLLER WITH AN LPC INTERFACE ...
    SMSC
  • 英文版
    128 PIN ENGANCED SUPER I/O CONTROLLER WITH AN LPC INT...
    SMSC [SMSC...
  • 英文版
    ADVANCED I/O CONTROLLER WITH MOTHERBOARD GLUE LOGIC
    SMSC
  • 英文版
    ADVANCED I/O CONTROLLER WITH MOTHERBOARD GLUE LOGIC
    SMSC [SMSC...
  • 英文版
    ADVANCED I/O CONTROLLER WITH MOTHERBOARD GLUE LOGIC
    SMSC
  • 英文版
    ADVANCED I/O CONTROLLER WITH MOTHERBOARD GLUE LOGIC
    SMSC [SMSC...
  • 英文版
    LPC SUPER I/O WITH HARDWARE MONITORING BLOCK
    SMSC
  • 英文版
    LPC SUPER I/O WITH HARDWARE MONITORING BLOCK
    SMSC [SMSC...
  • 英文版
    SMSC Corporation [LPC Super I/O IrDA Hot Docking Chip with ...
    SMSC

掃碼下載APP，
一鍵連接廣大的電子世界。

在線人工客服

買家服務：
賣家服務：
技術客服：

0571-85317607

網站技術支持

13606545031

客服在線時間周一至周五
9:00-17:30

關注官方微信號，
第一時間獲取資訊。

建議反饋

聯系人：

聯系方式：

按住滑塊，拖拽到最右邊
>>
感謝您向阿庫提出的寶貴意見，您的參與是維庫提升服務的動力！意見一經采納，將有感恩紅包奉上哦！