鈥?/div>
Power-Up Sequence
256M GDDR SDRAM
DDR SDRAMs must be powered up and initialized in a predefined manner to prevent undefined operations.
1. Apply power and keep CKE at low state (All other inputs may be undefined)
- Apply VDD before VDDQ .
- Apply VDDQ before VREF & VTT
2. Start clock and maintain stable condition for minimum 200us.
3. The minimum of 200us after stable power and clock(CK,CK ), apply NOP and take CKE to be high .
4. Issue precharge command for all banks of the device.
5. Issue a EMRS command to enable DLL
(Minimum 20 clock cycles are recommended prior to MRS command, however not mandatory just in case tMRD met)
*1
*
1,2
6. Issue a MRS command to reset DLL. The additional 200 clock cycles are required to lock the DLL.
7. Issue precharge command for all banks of the device.
8. Issue at least 2 or more auto-refresh commands.
9. Issue a mode register set command with A8 to low to initialize the mode register.
*1 The additional 200cycles of clock input is required to lock the DLL after enabling DLL.
*2 Sequence of 6&7 is regardless of the order
Power up & Initialization Sequence
~
~
~
~
~
~
CK,CK
t
RP
~
tMRD.
tMRD
tRP
t
RFC
t
RFC
tMRD
Mode
Register Set
~
~
~
~
~
~
~
precharge
ALL Banks
EMRS
MRS
DLL Reset
precharge
ALL Banks
1st Auto
Refresh
2nd Auto
Refresh
~
Command
~
Any
Command
Inputs must be
stable for 200us
200 Clock min.
* When the operating frequency is changed, DLL reset should be required again.
After DLL reset again, the minimum 200 cycles of clock input is needed to lock the DLL.
- 7 -
Rev 1.3 (Mar. 2005)