L484
PIN FUNCTIONS
(refer to fig. 2)
N擄
1
Name
CURRENT SENSING
INPUT
Function
Connection for Coil Current Limitation. The current is measured on the
sense resistor R
SENS
and divided on R1/R2. The current limitation value is
given by :
R1
+
R2
I
SENS
=
R
SENS
R2
Magnetic Pickup Signal Input. This pin sets the dwell time, i.e. the max
negative pickup voltage value starting from which the device can drive the
current into the coil. The real dwell time will be a function of the dwell
control logic. Increasing the resistor R11 the maximum conduction time
increases. The max input current foreseen is 2mA.
A capacitor C1 connected between this pin and ground sets the delay of the
permanent conduction protection in the coil current. Using a 50nF capacitor
the typical desaturation time delay for the protection is 75ms.
2
PICKUP INPUT
3
PERMANENT
CONDUCT.
PROTECTION TIMER
4
5
6
PERMANENT CONDUCT. A low level on this input (max 0.7V) disables the protection, irrespective of
PROTECTION INHIBIT the state of pin 3. If the protection is used this pin must be left open.
RPM OUTPUT
DWELL TIME ADJUST
Open collector output signal which is at a low level when the final darlington
is in ON status. The current is internally limited at 10mA.
At high motor rotation speeds, i.e. when the peak value of the magnetic
pick-up signal exceedes 6V using R12 = 100K鈩? this pin may be used to
vary the dwell ratio. Adding a resistor in series R
a
between this pin and pin
11 the desaturation time is reduced. It is therefore possible to use this pin to
adapt the L484 to various pickup types. The maximum value of the resistor
R
a
is 200K鈩?
A capacitor C2 connected between this pin and ground sets the timing for
the dwell control. The recommended value is 100nF. The resistors R
b
/R
c
provide an hysteresis to confirm ON state and avoid spurious sparks.
Zero cross detector input of the magnetic pickup signal for the ignition
actuation. At high motor rotation speeds, the external resistor R12 may be
used to vary the desaturation time ratio, to adapt the L484 to various
signal waveforms of time magnetic pick-up. Reducing the resistor value the
dwell time increases. Typically the range of values for resistor R12 is from
50K鈩?to 150K鈩?.
A low level on this pin forces the external darlington into conduction
particularly useful in anti knock system. This function is particularly useful in
antiknock system because provides a spark time delay. Anyway the current
limitation, the permanent conduction protection and the dump protection
are operating even when pin 9 is at a low level. If this function is not used it
must be left open.
This pin must be connected to ground.
Supply Voltage Input. A 7V (typ) zener is present at the input. The external
resistor R9 limits the current through the zener for higher supply voltages.
The device is protected against the load dump. In load dump condition an
internal circuit, based on a zener diode and a darlington transistor,
switches off the external darlington and short circuits the supply.
By means of the external divider R8/R9 the protection threshold can be
changed and is given as first approximation by:
錚?/div>
R8
+
R9
錚?/div>
鈭?
V
Dth
=
8.5
錚?/div>
錚?+
5
鈰?/div>
10 R8
R9
錚?/div>
錚?/div>
(the resistor R9 value must be higher than 4K鈩?.
7
DWELL CONTROL
TIMER
ZERO CROSSING
INPUT
8
9
POWER-ON INPUT
10
11
12
SIGNAL GROUND
POWER SUPPLY
DUMP PROTECTION
13
POWER GROUND
This pin must be connected to ground.
* this function is particularly useful in antiknock systeme because provides a spark time delay. anyway the current limitation, the pemanent con
duction protection and the dump protection are operating even when pin 9 is at a low level.
3/11
L484D1 產品屬性
50
集成電路 (IC)
PMIC - 電源管理 - 專用
-
自動
-
6 V ~ 28 V
-40°C ~ 125°C
表面貼裝
16-SOIC（0.154"，3.90mm 寬）
16-SOIC
管件
L484D1相關型號PDF文件下載
-
型號
版本
描述
廠商
下載
-
英文版
MAGNETIC PICKUP IGNITION CONTROLLER
-
英文版
MAGNETIC PICKUP IGNITION CONTROLLER
STMICROELECTRON...
-
英文版
MAGNETIC PICKUP IGNITION CONTROLLER
-
英文版
MAGNETIC PICKUP IGNITION CONTROLLER
STMICROELECTRON...
-
英文版
MAGNETIC PICKUP IGNITION CONTROLLER
-
英文版
MAGNETIC PICKUP IGNITION CONTROLLER
STMICROELECTRON...
STMICROELECTRONICS
1
2
3
4
5
6
7
8
9
10
11
