/pci@8,700000/IntraServer,fc@2/disk
/pci@8,700000/IntraServer,fc@2/tape
/pci@8,700000/IntraServer,fc@1,1/disk
/pci@8,700000/IntraServer,fc@1,1/tape
/pci@8,700000/IntraServer,fc@1/disk
/pci@8,700000/IntraServer,fc@1/tape
/pci@8,700000/scsi@6,1/tape
/pci@8,700000/scsi@6,1/disk
ok
鈥?/div>
/pci@8,700000/IntraServer,fc@1
identi鏗乪s the
鏗乺st
Fibre Channel interface on an LSI Logic LSIFC929-
based adapter.
/pci@8,700000/IntraServer,fc@1,1
identi鏗乪s the
second
Fibre Channel interface on an LSI Logic
LSIFC929-based adapter.
An LSI Logic LSIFC919-based adapter will show only one such Fibre
Channel device.
Note:
The above are examples. The output of
show-devs
may
vary depending on your system and con鏗乬uration. Use the
corresponding entries on your system, not the ones given
here.
鈥?/div>
鈥?/div>
If these devices are not listed, check to assure that the adapter is
correctly installed, and re-seat the adapter in the PCI slot if necessary.
4.8.4 Adapter-Speci鏗乧 Settings
In certain circumstances, the advanced user may want to change
settings for an individual adapter or port, without affecting the other
adapters in the system. Speci鏗乧 examples of such settings are Fibre
Channel bus speed, host adapter ID (SCSI only: Not Applicable to Fibre
Channel), and Interrupt Coalescing.
To select a speci鏗乧 Fusion-MPT adapter as the current adapter, use the
select
command. Selecting a port or adapter brings the port online, and
allows you to show or set certain adapter speci鏗乧 parameters.
You should use caution while issuing the following commands, as some
commands could render the bus unusable (such as forcing 1 Gbit/s
operation on a 2 Gbit/s Fibre Channel loop).
4-10
BIOS Features
Ver. 2.0
Copyright 漏 2002 by LSI Logic Corporation. All rights reserved.
prev
next