最新免费av在线观看,亚洲综合一区成人在线,中文字幕精品无码一区二区三区,中文人妻av高清一区二区,中文字幕乱偷无码av先锋

UCC28220 Datasheet

  • UCC28220

  • 具有可編程最大占空比的雙路交錯 PWM 控制器

  • 28頁

  • TI

掃碼查看芯片數據手冊

上傳產品規格書

PDF預覽

UCC28220, UCC28221
SLUS544A 鈭?SEPTEMBER 2003 鈭?REVISED AUGUST 2004
APPLICATION INFORMATION
Reference
For improved noise immunity it is recommended that the reference pin, REF, be bypassed with a minimum of
0.1uF of capacitance to GND.
Oscillator Operation and Maximum Duty Cycle Setpoint
The oscillator uses an internal capacitor to generate the time base for both PWM channels. The oscillator is
programmable over a 200 kHz to 2MHz frequency range with 20% to 80% maximum duty cycle range. Both the
dead time and the frequency of the oscillator are divided by 2 to generate the PWM clock and off-time information
for each of the outputs. In this way, a 20% oscillator duty cycle corresponds to a 60% maximum duty cycle at
each output, where an 80% oscillator duty cycle yields a 90% duty cycle clamp at each output.
The design equations for the oscillator and maximum duty cycle set point are given by:
F
OSC
+
2
F
OUT
1
*
D
MAX(out)
(5)
(6)
D
MAX(osc)
+
1
*
2
R
CHG
+
K
OSC
D
MAX(osc)
F
OSC
1
*
D
MAX(osc)
F
OSC
(8)
(7)
R
DISCHG
+
K
OSC
Where:
鈥?/div>
鈥?/div>
鈥?/div>
鈥?/div>
鈥?/div>
鈥?/div>
鈥?/div>
K
OSC
= 2.04 x 10
10
[鈩?s]
F
OUT
= Switching frequency at the outputs of the chip [Hz]
D
MAX(out)
= Maximum duty cycle limit at the outputs of the chip
D
MAX(osc)
= Maximum duty cycle of the Oscillator for the desired maximum duty cycle at the outputs
F
OSC
= Oscillator frequency for desired output frequency [Hz]
R
CHG
= External oscillator resistor which sets the charge current 鈭?[鈩
R
DISCHG
= External oscillator resistor which sets the discharge current 鈭?[鈩
Start-Up JFET Section
A 110-V start-up JFET is included to start the device from a wide range (36 V鈭?5 V) telecom input source. When
VDD is lower than 13 V the JFET is on, behaving as a current source charging the bias capacitors on VDD and
supplying current to the device. In this way, the VDD bypass capacitors are charged to 13 V where the outputs
start switching and the JFET is turned off. To enable a constant bias supply to the device during a pulse skipping
condition, the JFET is turned back on whenever VDD decreases below 10 V and the outputs are not switching.
Thus, the current from the JFET can overcome the internal bias currents, as long as the device is not actively
switching the output drivers. See Figure 2 below for a graphical representation of the JFET/VDD operation. The
UCC28220 does not contain an internal JFET and has a startup threshold of 10 V which makes it capable of
directly operating off a 12 V dc bus
www.ti.com
11

UCC28220 PDF文件相關型號

UCC28221

UCC28220相關型號PDF文件下載

  • 型號
    版本
    描述
    廠商
    下載
  • 英文版
    Low Dropout 3 Ampere Linear Regulator Family
    TI
  • 英文版
    Low Dropout 3 Ampere Linear Regulator Family
    TI [Texas ...
  • 英文版
    Low Dropout 1 Ampere Linear Regulator Family
    TI [Texas ...
  • 英文版
    Low Dropout 0.5A Negative Linear Regulator
    TI [Texas ...
  • 英文版
    HID Lamp Controller
    TI
  • 英文版
    HID Lamp Controller
    TI [Texas ...
  • 英文版
    HIGH EFFICIENCY SECONDARY SIDE SYNCHRONOUS BUCK PWM CONTROLL...
    TI
  • 英文版
    HIGH EFFICIENCY SECONDARY SIDE SYNCHRONOUS BUCK PWM CONTROLL...
    TI [Texas ...
  • 英文版
    HIGH-EFFICIENCY SYNCHRONOUS BUCK PWM CONTROLLER
    TI [Texas ...
  • 英文版
    Low Power Pulse Width Modulator
    TI
  • 英文版
    Low Power Pulse Width Modulator
    TI [Texas ...
  • 英文版
    Micropower Voltage Mode PWM
    TI
  • 英文版
    Micropower Voltage Mode PWM
    TI [Texas ...
  • 英文版
    Switch Mode Secondary Side Post Regulator
    TI
  • 英文版
    Switch Mode Secondary Side Post Regulator
    TI [Texas ...
  • 英文版
    Low Voltage Synchronous Buck Controller
    TI
  • 英文版
    Low Voltage Synchronous Buck Controller
    TI [Texas ...
  • 英文版
    Brushless DC Motor Controller
    TI
  • 英文版
    Brushless DC Motor Controller
    TI [Texas ...
  • 英文版
    Source Ringer Controller
    TI

掃碼下載APP，
一鍵連接廣大的電子世界。

在線人工客服

買家服務：
賣家服務：
技術客服：

0571-85317607

網站技術支持

13606545031

客服在線時間周一至周五
9:00-17:30

關注官方微信號，
第一時間獲取資訊。

建議反饋

聯系人：

聯系方式：

按住滑塊，拖拽到最右邊
>>
感謝您向阿庫提出的寶貴意見，您的參與是維庫提升服務的動力！意見一經采納，將有感恩紅包奉上哦！